- Remove Base.
- Remove all rotary and slide pot knobs.
- Remove four (4) 3/8 nuts and finishing washers from rear panel phone jacks.
- Release Board 2 from the rear panel.
- Remove three (3) screws securing the front of Board 1 to housing.
- Remove three (3) screws from rear panel securing PCB guide.
- Remove P.C. Boards 1 and 2 together.
- Disconnect keyboard and left hand control connectors.
- (Reassembly Note: Center switch levers mechanically to clear front panel holes.)
Source: Rogue — moog-rogue-service-manual (manual)