- Disconnect power and all cables.
- Undo the 8 screws on the top panel and remove assembly from chassis.
- Disconnect the two cables from the main PCB.
- Connect the 10-pin end P1 of the supplied adapter cable to connector X23 on the Main PCB.
- Turn off the Eurorack power supply.
- Connect the 16-pin end P2 to the power supply, ensuring pins 3-8 are Ground and pins 9-10 are +12 VDC.
- Install the MODEL D into the rack using 8 screws.
- Perform a safety test.
Source: Minimoog Model D — model-d-qsg-ww (manual)